tag:blogger.com,1999:blog-35333449.post8883891571101081065..comments2023-12-04T08:00:08.414-05:00Comments on Last Refuge of a Scoundrel: Barriers - BrokenLarryhttp://www.blogger.com/profile/11308171394825291900noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-35333449.post-38770871023332320052012-10-16T08:19:13.755-04:002012-10-16T08:19:13.755-04:00Oh yes, N scale and narrow gauge if that isn't...Oh yes, N scale and narrow gauge if that isn't bad enough. I even have another site for it, although I don't update it (or model) as much as I want to.<br /><br />http://pvrr.blogspot.com/<br /><br />You might check out Shapeways and see what they have, lots of model railroaders are using them to make all sorts of things.<br /><br />Thanks for dropping by!Larryhttps://www.blogger.com/profile/11308171394825291900noreply@blogger.comtag:blogger.com,1999:blog-35333449.post-90678272981804044352012-10-15T23:45:08.314-04:002012-10-15T23:45:08.314-04:00After all this time, I never knew you were into mo...After all this time, I never knew you were into model railroading. Me too! Here's my most recent creation: http://mylifestime.com/2012/09/24/ack-where-have-i-been/<br /><br />As far as the 3-D Printers go, that would be awesome, especially if you want to create a series of buildings that are period-specific. One of the problems I had with the layout above was that it needed a station and a church building that looked similar to my church. Unfortunately, there weren't any models out there that I thought were "good enough", so I ended up leaving the flat area bare instead.<br /><br />U.S. Common Sensehttps://www.blogger.com/profile/10137770836963183159noreply@blogger.comtag:blogger.com,1999:blog-35333449.post-78359349667974680242012-10-11T09:42:13.826-04:002012-10-11T09:42:13.826-04:00I'm pretty sure it would have to have custom m...I'm pretty sure it would have to have custom made printer drivers, no telling how they would change them.<br />Thanks for dropping by RA!Larryhttps://www.blogger.com/profile/11308171394825291900noreply@blogger.comtag:blogger.com,1999:blog-35333449.post-10148619314828471992012-10-07T22:15:27.884-04:002012-10-07T22:15:27.884-04:00Awesome! But I bet Micro$oft screws with the 3D p...Awesome! But I bet Micro$oft screws with the 3D printer drivers in Windows8...RabidAlienhttps://www.blogger.com/profile/07035887632706442114noreply@blogger.com