A preliminary report can be found here, but it's scarce on details.
The first thing that was done was a sighting in at 25 yards, just to make sure everything was close enough to mark the paper. The Arisaka shot slightly high and right, about the same distance high as right, but close enough to get on the paper (or so we thought at the time).
The Saiga was also high, but slightly left. Once again, it was determined to be close enough to get on the paper.
We set the targets up at the 200 yard line and prepped the rifles. Five shots out of the Arisaka and ten out of the Saiga, and a peek through the spotting scope revealed that...
Actually it revealed that the spotting scope wasn't strong enough for 200 yards, so we had to hike the distance back to the targets. The Arisaka was high and right enough to be off the paper and on the cardboard, the Saiga was high and slightly left.
Back on the firing line the Saiga got it's sights adjusted, and we decided to fire one rifle at a time and check shot placement after each magazine (the ulterior motive was to make sure all the ammo would feed out of each of the Saiga magazines since I had some trouble with one or two of them before). Each round of firing required a 200 yard hike to the target and 200 yards back.
Since the Saiga had more capacity we started with it. By the time we were through the third magazine we had it sighted in fairly well, so the fourth magazine grouped right in the middle where it should have been. The group was in a pattern about eight inches or so across (32 rounds in each magazine) scattered evenly around the X, so not bad for iron sights.
Next we attempted to sight in the Arisaka. Attempted I say, because the tool we used on the Saiga did absolutely nothing for the Arisaka. We put 20 rounds through it total and it consistently shot about eight to ten inches high and eight to ten inches to the right, but the grouping was pretty good at about 4 to 5 inches for a 5 round magazine (once again, iron sights).
I don't know how the elevation problem is going to get resolved because there is absolutely no adjustment for elevation, but with the proper tool I should be able to get the azimuth dialed in. There didn't seem to be any performance differences between the 129 grain and the 140 grain bullets, the original Japanese rounds were 139 grains so I'll probably stick with the 140 grain rounds unless I get a good deal on something else.
We have also decided that 100 yards is a good enough distance, and since the spotting scope is good for 100 yards it would cut down on the hiking time.
Next we moved over to the pistol and shotgun range. I pulled the plug out of the Franchi and wanted to see how it did. With the plug out the magazine holds 4 rounds, two more than with the plug in. To load 5 rounds you have to first load the chamber and then load the magazine, which is kind of a pain in the nether regions due to the way the semi-auto feed system works. The grouping with a modified choke installed (the Franchi has screw in chokes, unlike the pump-action Mossberg) was pretty good at 25 yards, so it would be a good duck gun (with the plug in, of course).
I then shot about 75 rounds through the Glock and made a big hole in the middle of the paper at six yards, so I'm happy with that. I had absolutely no feed issues this time, not like during quals when I had one stovepipe on me. It may have been something to do with the ammo I purchased from the range, the ammo I had on hand did just fine.
After all was said and done and the toys were put away I said something about getting a Mosin Nagant to play with since it would be cheaper to feed than the Arisaka. As luck would have it my range buddy just so happened to have one, along with enough ammo that I should be able to pass it down to my grandkids. Russian surplus, so I'll have to get some good cleaner for the bore, but plenty of it.
So now my gun safe is multicultural; I have two Russian rifles, one Japanese rifle (the older Russian and the Japanese rifles might have either faced each other or served side by side, they are about the same age*), one American rifle and one American pump shotgun, one Italian semi-auto shotgun, and an Austrian pistol. I have rifle calibers in .22, .223, 6.5 x 50 and 7.62 x 54R so all my bases should pretty well be covered. Both shotguns are 12 gauge and the Glock is .45 so I'm pretty well equipped there, too. I'd like to get another .357 before I'm all done, maybe a 9mm and a .380, but by now I have the "needs" covered and so I'm down to "wants."
The next thing I need to do is find the proper sight adjusting tool for the Arisaka (and more ammo for it), then I will take it and the Mosin out to see how they do.
*EDIT: The Mosin and the Arisaka are not, in fact, about the same age; the Mosin is forty years younger. The Arisaka T-30 was produced in a four or five year span right around 1900 and the Mosin was made in 1943.
Getting There
10 months ago
4 comments:
My crazy ass papaw used to tell us he had a gun he took off a dead Jap, but I think he just got it in a pawn shop from a really skinny Asian dude that coughed a lot.
Maybe the pawn shop guy bit the dust afterwards and that's what he meant?
Thanks for dropping by!
No pics? :)
Unfortunately I did not bring my camera. I'll have to remember it for the next time.
Thanks for dropping by!
Post a Comment